Mobile Gas Ejector Package

Name: MKEG — Mobile Gas Ejector Package
SKU: MKEG

A package that entrains low-pressure gas into a higher-pressure stream using the energy of a motive fluid.

Request a technical and commercial proposal

Purpose

Recover low-pressure gas, reduce flaring and use an available pressure differential without a separate mechanical compressor.

Process arrangement

Simplified process diagram

The diagram identifies the principal process duties, equipment connections and product handover points. Final scope, redundancy and battery limits are established from project data.

MKEGMobile gas-ejector package configurationsSimplified process diagram

Process mediumGasRecycle

The gas-gas configuration uses higher-pressure motive gas. The liquid-gas configuration circulates motive liquid through a pump, ejector and separator. Low-pressure gas enters the ejector in both arrangements.

Engineering basis

Technical parameters

Final ratings, materials and supply scope are established from project-specific operating data.

Motive stream	high-pressure gas or motive liquid, depending on the selected arrangement
Suction stream	low-pressure gas over the specified flow range
Discharge pressure	to the mixed-stream tie-in conditions
Operating point	from ejector design and the three-stream balance

Process functions

Principal process duties

Motive-stream conditioning and control
Low-pressure gas entrainment and mixing
Mixed-stream pressure recovery
Liquid knockout where required
Operating-point control and backflow protection

Typical scope

Main equipment

01
Ejector designed for the project flow balance
02
Separation, filtration and control valves
03
Instrumentation, bypass and emergency protection
04
Power distribution, heat tracing, lighting and earthing
05
Maintenance platforms, shelters and transport provisions as required

Questionnaire

Data required for engineering

Worked examples and vessel-volume fields are retained. Use them as guidance or provide parameters from an existing design.

Submit operating data

01
Motive-stream composition, flow, pressure and temperature
02
Suction-gas composition, flow, pressure and temperature
03
Required mixed-stream discharge pressure
04
Required turndown and transient operating cases
05
Liquid, solids and corrosive-component content

Proposal request

Operating data for a technical and commercial proposal

Attach the completed questionnaire or provide the principal operating data below. Equipment scope, design ratings and battery limits follow engineering review.

Email the questionnaire, specification and attachments