NGSV / TFS / R
Three-Phase Separators
Vessels for simultaneous separation into gas, oil or condensate, and water.
View detailsMobile facility
MUPNMobile Oil Treatment Facility
A multistage mobile facility for oil separation, dehydration, desalting, metering and export.
Purpose
Provide early or temporary oil treatment when permanent infrastructure is unavailable, constrained or remote.
Process arrangement
Simplified process diagram
The diagram identifies the principal process duties, equipment connections and product handover points. Final scope, redundancy and battery limits are established from project data.
Process mediumOil / emulsionGasWater
The simplified diagram identifies the principal process duties and product handover points. Final equipment scope is established from project data.
Engineering basis
Technical parameters
Final ratings, materials and supply scope are established from project-specific operating data.
| Liquid capacity | up to 12,000 t/d* |
|---|---|
| Oil capacity | up to 8,000 t/d* |
| Gas capacity | up to 3,000 thousand Nm³/d* |
| Inlet pressure | up to 6.3 MPa* |
| Outlet oil water content | up to 0.5 vol.%* |
| Mechanical impurities | not more than 0.05 wt.%* |
Process functions
Principal process duties
- Multistage wellstream separation
- Heating, demulsification, dehydration and desalting
- Associated-gas and produced-water treatment
- Fiscal or operational outlet metering
- Pipeline export or truck loading
Typical scope
Main equipment
- 01
Inlet manifold and first-stage separation
- 02
Three-phase separators, heaters and settlers
- 03
Pumping, metering, gas and chemical modules
- 04
Truck loading or pipeline tie-in system
- 05
Instrumentation, emergency shutdown and process control
- 06
Power distribution, heat tracing, lighting and earthing
- 07
Maintenance platforms, shelters and transport provisions as required
Questionnaire
Data required for engineering
Worked examples and vessel-volume fields are retained. Use them as guidance or provide parameters from an existing design.
- 01
Minimum, normal and maximum liquid, oil, water and gas rates
- 02
Wellstream composition and physical properties
- 03
Inlet pressure and temperature, allowable pressure drop
- 04
Required outlet-stream quality and export destinations
- 05
Climate, site category, available utilities and transport constraints
Proposal request
Operating data for a technical and commercial proposal
Attach the completed questionnaire or provide the principal operating data below. Equipment scope, design ratings and battery limits follow engineering review.
Email the questionnaire, specification and attachmentsFacility composition
Principal equipment and process packages
The list reflects a typical functional structure. Process stages, redundancy and battery limits are established by engineering calculations.
PTB
PTB Packaged Tubular Heaters
Packaged direct-fired tubular heaters for crude oil, oil emulsions, petroleum products and other process streams.
View details
ISK
Controlled Mixing Packages
Controlled packages for mixing crude oil with wash water and chemicals upstream of an electrostatic dehydrator.
View details
EDG
Electrostatic Dehydrators
Electrostatic coalescers for deep crude-oil dehydration and desalting.
View details
ON
ON Oil Settlers
Horizontal vessels for gravity dehydration of crude-oil emulsion with engineered residence time and interface control.
View detailsRelated scope
Equipment in the same category
MUPSV
Mobile Produced-Water Separation Unit
A mobile three-phase facility for separating gas, oil and produced water directly at a well pad or field site.
View details
MBPN
Mobile Oil Treatment Module
A single- or compact multi-module solution for heating, separation, settling and dehydration of oil emulsion.
View details